Switches | Outlets & Plugs | Ballasts | Replace Ballasts | LED Tube Lights | Troubleshooting | Basic Electricity  | Misc Articles

Question or Comment?

    Electrical 101   

About      Privacy Policy      Sitemap      Copyright © 2024 Electrical101.com      Terms of Use

Alternate 2 Lamp Rapid Start Ballast Diagram

Factory wiring

How to Replace Alternate 2 Lamp Rapid Start Ballast with Instant Start

This ballast could be replaced with a 2 lamp T8 instant start electronic ballast.

1. Connect each of the individual blue wires from the instant start ballast to each pair of the lampholder individual wires (red and blue).
2. Connect the common red wire to the yellow, blue, and red wires of the common lampholders. A blue wire connector can be used to connect these four 18 AWG wires together. However, a larger orange wire connector would be a better choice if available.

Alternate 2 Lamp Rapid Start Ballast Replaced with Instant Start Diagram

This diagram shows a variation of a 2 lamp rapid start ballast wiring one of our readers encountered.

Replace

Ballasts

Replace 1 Lamp Rapid Start with 2 Lamp Instant Start

Replace 1 Lamp Rapid Start with 2 Lamp Rapid Start

Replace 2 Lamp Instant Start

Replace 2 Lamp Rapid Start with Instant Start

Replace Alternate 2 Lamp Rapid Start with Instant Start

Replace 2 Lamp Rapid Start

Replace 3 Lamp Instant Start

Replace 3 Lamp Two Instant Start with One Instant Start

Replace 3 Lamp Rapid Start with Instant Start

Replace 3 Lamp Two Rapid Start with One Instant Start

Replace 3 Lamp Programmed Start with Instant Start

Replace 3 Lamp Programmed Start with Rapid Start

Replace 4 Lamp Instant Start

Replace 4 Lamp Two Rapid Start with One Instant Start

Replace 4 Lamp Rapid Start with Instant Start